TB42E on Gas

5562sean

Member
Hi everyone,
just after a bit of advice about my tb42e on gas. I have recently put a new head and gasket on and all was good until one day it backfired. This destroyed the old stubby holder and I replaced it with a new stubby holder but its not the same. Whenever I put my foot down it struggles for air after 2000rpm, if i put a hole it wont idle if i leave it whole it wont rev up.
Just want to know what is actually supposed to go in the gap between the converter and intake manifold.
Any help, suggestions, remedied appreciated.
 
Top