superchargers

Blundo

New Member
G'day all,
I have a question that someone out there may be able to help with. First of all I don't want any info on turbo's, I already know how to build big horsepower with a turbo- I have a couple of mates with 350ish hp diesels. I don't think a turbo will suit the way I drive.

I have a gq patrol with a 4.2 diesel, manual. I am concious of my fuel economy when I drive so I tend to use torque rather than hp(I've got none anyway). It barely gets past 2500rpm, maybe 3000 if I have to get out into traffic in a hurry. I will take it to the rev limiter when I'm climbing a steep hill in the bush but thats it.

So here's my question. I want to do something different and put a supercharger on my truck. I have heard of people putting toyota sc12 or sc14's on cars with similar size engines before. Then there's the eaton m90 which has better technology in it than the toyotas but is only .07 of a litre bigger in output. All of these are roots type blowers.
sc12- 1.2lt/rotation
sc14- 1.4lt/ rot
m90- 1.47lt/rot
Then there are twin screw superchargers like the ihi mazda 1.2lt. From what I have found out this blower is good to 400hp. Slightly smaller blower but screw type- way better technology, like a sprintex.

Has anyone done this before or know someone who has done this before? I can make all the bits I need to make it fit. I have a limited budget and am trying to do it very cheap. Do any of these chargers work ok on a 4.2 diesel or should I be looking at a larger screw type like autorotor 2.4lt, sprintex, whipple etc. I reckon I can buy a second hand smaller blower and make all the fabrications for less than I can buy a bigger blower.

I am only out to put in 10-12 psi (intercooled). I really just want massive torque down low and mid range. 10-12 psi will be heaps of hp for what I want. Does anyone have real life experience or know someone who has? I know a smaller blower will work a lot harder but will it do what I want?

Any info would be great,
Thanks
John.
 

Jarh73

New Member
No doubt a supercharger will give you what you want right down low circa 1000rpm and if that's your priority.

Problem is no matter how you add it up a turbo is the most efficient means of increasing midrange. I realise you don't want a turbo but reality is it's the midrange king.

No sure how recently you have been involved in diesel turbos but many of the top tuners can give you a turbo in 200rpm increments so you can get the best turbo for your intended operating RPM.

For the supercharger as long as it flows enough air for the application you can't go to far wrong.

Absolutely critical and usually overlooked is the injection advance curve, big pay offs if you get that right.

Cheers

Justin
 

Alby123

Active Member
Hi Blundo, I also have a GQ 92 4.2lt N/A diesel and have spent many hours doing research on what you are in tending to do. One of the biggest things that I found that putting on a supercharger does give you all the torque and power you could wish for. but that all comes with a big price tag for the supercharger and you would also have to be conciouis of the fact that you fuel economy will probably go up to 17-20lts/100kms. This depends on how you use the accelerator. At the end of my research I've decided that it would be far better for me to have a 6.2lt v8 N/A diesel. Currently I have a snorkel, Hi-clone vent, LPG via air intake and add Chemtech Diesel additive. I was wondering do you tow a camper trailer or a caravan as this sometimes makes the decision easier to achieve the desired result. Cheers Alby
 

Blundo

New Member
Thanks for the information

Thanks for the info guys,
I have contemplated an engine swap. If I did go that way it would probably be a 6.0lt chev. I'm not really a chev person but you can't build a small block ford that is as good as a factory 6.0lt for the money. If I did an engine swap I would not go diesel. One of my mates has a turbo 351 cleveland in a 4x4, it puts out 512hp (10-12 psi) at the tyres on 35's. Cost him $10/100km on gas (when driven right). Thats very hard to match in a diesel of any kind.

I was really after something different and some low down pulling power. I am not opposed to turbos, I actually have one in the shed I could put on it, I just have not driven one that pulls below 1500rpm. I have since found out that although a small blower would possibly work ok to about 6-8 psi, the ones I was looking at are simply not big enough to work properly on a diesel of my size. They might work ok down low but the limitation on air flow in the upper range would create more problems than they fix.

It is looking like I will just put the turbo on, fiddle with a few things to make it go as best suits my needs and change my driving style. If it effects my fuel economy too much I'll sell it and start again with a petrol (v8 and gas conversion) and maybe a GU next time. One of my mates makes a convincing arguement- we can have everything manufactured and the turbo on in a weekend whereas it will take possibly 1-2 week's work to manufacture and install a supercharger. Because I only have saturdays and the occasional sunday to work on it that means possibly 10 weeks before it would be ready as compared to 1.

Oh well something to think about but I think my mind may be made up. Thanks again for the info, I have to go get some tools out.
 

croozza

Active Member
One of my mates had a GQ, and put a supercharger on it, first thing we noticed was the already rattley 4.2 got an even louder rattle at idle. Secondly, yes you do get substancial torque gains from idle, however it never came close to outracing my N/A 1HZ 80 Series. He even ran 10psi boost by changing the size of the drive pully, it used the same supercharger as found in the VS & VT Commodores, so it is a twin screw type Eaton Supercharger. He may still have a few intake manifolds in storage...
Personally, your current motor will be getting too long in the tooth to just bolt on the supercharger, so an engine rebuild will be needed, or it could be cheaper just to do an engine transplant.
 

Blundo

New Member
I really just wanted to do something different but it is not feasable at the moment. I have a turbo so I don't need to buy very much. The blower I need to work properly would have to be much bigger than the ones I was looking at. They may work ok for a petrol but not a diesel- not big enough cfm.

The commodore superchargers are an eaton M90. They are a roots type blower not a twin screw. There is a very big difference in the way they work. A twin screw is far more efficient and generates a lot less heat. I have since spoken to some so called experts (from the states) who tell me I will need at least 1.8- 2.0lt/ rev, which is probably why an M90 doesn't work so well on a 4.2. They are talking 2.4 lysholm blowers which are almost 1 litre bigger than a M90, in a twin screw aswell.

I think I will just bung on the turbo. I haven't owned a cruiser for years so I don't remember what their motors are like, but mines going fantastic. Now I think about it thats why I changed to a nissan. Sorry mate couldn't help but have a dig.

Anyway thanks heaps for the info
Blundo
 

Fourex

Member
G'day all,
I have a question that someone out there may be able to help with. First of all I don't want any info on turbo's, I already know how to build big horsepower with a turbo- I have a couple of mates with 350ish hp diesels. I don't think a turbo will suit the way I drive.

I have a gq patrol with a 4.2 diesel, manual. I am concious of my fuel economy when I drive so I tend to use torque rather than hp(I've got none anyway). It barely gets past 2500rpm, maybe 3000 if I have to get out into traffic in a hurry. I will take it to the rev limiter when I'm climbing a steep hill in the bush but thats it.

So here's my question. I want to do something different and put a supercharger on my truck. I have heard of people putting toyota sc12 or sc14's on cars with similar size engines before. Then there's the eaton m90 which has better technology in it than the toyotas but is only .07 of a litre bigger in output. All of these are roots type blowers.
sc12- 1.2lt/rotation
sc14- 1.4lt/ rot
m90- 1.47lt/rot
Then there are twin screw superchargers like the ihi mazda 1.2lt. From what I have found out this blower is good to 400hp. Slightly smaller blower but screw type- way better technology, like a sprintex.

Has anyone done this before or know someone who has done this before? I can make all the bits I need to make it fit. I have a limited budget and am trying to do it very cheap. Do any of these chargers work ok on a 4.2 diesel or should I be looking at a larger screw type like autorotor 2.4lt, sprintex, whipple etc. I reckon I can buy a second hand smaller blower and make all the fabrications for less than I can buy a bigger blower.

I am only out to put in 10-12 psi (intercooled). I really just want massive torque down low and mid range. 10-12 psi will be heaps of hp for what I want. Does anyone have real life experience or know someone who has? I know a smaller blower will work a lot harder but will it do what I want?

Any info would be great,
Thanks
John.

I did this on a Toyota 2.4 LT engine using the S.C.14 charger. It was more an experiment than anything. The 2.4 is a slow engine to start with, the turbocharged model (import 2lt) is a bit better....but one can never have too much power:) Low down grunt was really good, power right off idle, mid range to top end (2500-4000) was about the same as the turbo engines output. I first threw the charger onto the non turbo engine (aus. 2L) until it cooked a bigend bearing or 3, then rebuilt the 2LT turbo engine and put the charger onto it. After about 17,000 kays the blower sheared off its drive pulley bolts, probably due to the harmonic vibrations that get transferred from the crankshaft via the v belt drive. After the novelty of the blower whine wears off it starts to sound like a dentists drill, I ended up putting the turbo back on as this 4runner was my daily driver and I didn't have the time to play around with it anymore. If I did this again it would be with a quiet, modern blower, probably one with the inbuilt butterfly that cuts off boost at light throttle settings .
 
Top