re-gear 5.29 with 265/75/16

thejetstar

New Member
A few weeks got a set of 265/75/16 (around about 32") for my 1993 22r 4runner with Toyota 8inch diff. I live at Glasshouse so I 4x4 locally and it goes alright. But the other weekend went out to Landcruiser PK and the trip there was horrible. It is the first time I have taken it on the open road with the new tires it is a 5 speed but I had no chance of putting it in to fifth. The quickest it would go is around 90 and would loose speed straight away going up any hills it would only go about 50ks up the range(this is with the car fully loaded for camping).

I want to re-gear the diffs. Should I go to a 5.29??? Also noticed that my rear lsd is not working can this be fixed with a bearing kit???

This is a camping/4x4 car only. I only travel distances in the car when it is fully loaded and the only other time it is driven is at glasshouse 4x4ing.........mostly in low range
 

jacnden

Well-Known Member
you can find plenty of gear and tyre calculators online, and you will find that 32,s and 4.88 gears will bring you back to stock gearing. 5.29 would suit tyres over 33. I have 4.88 ring and pinion on order for my great wall which probably doesn't have much more power than you :) and 32 inch tyres slows me down a lot on the h/way
 

thejetstar

New Member
Thanks....where did you purchase yours from and how much was it? Finding hard to find online I can only see ones from America and you have to pay about $200 bucks postage
 

thejetstar

New Member
doin a little research I reckon 4.56 look pretty good.......does anyone have any experience in these diff ratio changes
 

Greylux

Member
Check out locktup4x4 they have a range of ring and pinion kits. Or you could check out eBay and buy a second hand complete centre and it makes for an easy swap. I went the secondhand route and haven't had any problems
 

joekar

Active Member
<snip>
Also noticed that my rear lsd is not working can this be fixed with a bearing kit???
<snip>

Other people have been answering the gearing question so I will address this one.

In short, no a bearing kit will not fix it.

The LSD is managed through clutches in the diff and it is this that you need to have rebuilt and/or reshimmed. I say and/or because Toyota LSDs are notoriously poor performers and your clutches may be in near new condition and just in need of resetting.

On the other hand you could just fit a locker. It may prove cheaper to fit an auto locker than to mess about with diff rebuilds.
 

thejetstar

New Member
yeah looking at putting a yukon grizly auto locker in the rear.........gonna replace both diffs with 2nd hand ones with ratios of 4.88 - 1
 
Top