NJ Pajero Taco stuck on 3000 rpm

Davidman

5th Annual Victorian Gathering member
Hi all,

1996 NJ Pajero (3.5 Petrol - Auto)

When I turn the ignition on, regardless of whether I start the vehicle or not, the taco needle moves to about 3000 rpm. It will stay in this position until the ignition is turned back off again. It doesn't matter if the car is running, doing tracks in low or sitting on 100 on the freeway, it will always stay on about 3000 until the car is turned off.

Any ideas please

Thanks
 

Campin40

Member
That's a new one. Usually it's the flashing green front wheels on the 4wd indacator. I couldn't stop the flashing so I just put tape over em. Maybe some tape over the tachco. Ha.ha. Only joking. Seriously though, I've got no idea what would make it do that. Must be driving you nuts..
 

BUSHNUT

Well-Known Member
Sounds like a feed coming overriding what is coming from the sender of the tachometer , the only thing I can think of is try and isolate all possible points of contact between the sender and the ignition switch , this may mean using a a wire with suitable contact clips that bypasses all the others in the loom , when you find which one doesn't create this behaviour and makes the tachometer behave as it should , that will be your answer . It is amazing how often it is within a loom , wires coming through their insulation . Have you taken it to a mechanic and see if anything comes up on any readout ?
 

Davidman

5th Annual Victorian Gathering member
Thanks for the quick feedback. Regarding the flashing orange and green lights, yes I have them too. Simmo, as it is not affecting anything, haven't had a mechanic look at it yet, sort of used to it, but it would be good if it was actually working. Think you're right though, electrical issue, dash is easy to remove, only a couple of screws, so might have a go at that over the weekend.
 

nightscale

Active Member
Thanks for the quick feedback. Regarding the flashing orange and green lights, yes I have them too. Simmo, as it is not affecting anything, haven't had a mechanic look at it yet, sort of used to it, but it would be good if it was actually working. Think you're right though, electrical issue, dash is easy to remove, only a couple of screws, so might have a go at that over the weekend.

Most of the time the flashy lights are just bad connectors on the sensors. Give them a clean and see how they go.

The tach could be a few things, the number one injector is the controller for the tacho. Or could be a dicky gauge thats dieing. Or the filter could be causing issues.
 

Lammi

Member
I am also having issues with my nj's tacho. Except mine is completely dead. I've got the cluster out and it all seems good behind there. Apparently most people sorted their issue by finding a noise filter on the firewall. I can't seem to find one. Anybody have any pictures?
 
Top