Carpet or Moulded Rubber

Harks76

New Member
We own a 2006 GU Patrol and on the weekend we noticed the carpet on the front drivers side was wet, After taking the carpert out we found it to be really wet. Now we are assuming that when we had it serviced the water got in when they pressured washed the engine bay be it a missing grommet or something like that.

What I would like to know though is it work taking the carpet out and replacing it with Moulded Rubber flooring and if so any recommendations would be greatly appreciated.

Cheers

Adam
 

Alien d2

4x4 Earth Contributer
Have a look at the drain hose from your heater box also.
It might be blocked not allowing the water to escape if you have been using the air conditioning.

Carpet/rubber debate I can't help you with but What is the major use?
If reguarly muddy then rubber is what I would do but carpet looks better(and better noise wise).
 

frosty

4x4 Earth Contributer
Rubber gets hot too. Carpet is nice so long as your prepared to pull it out every now and again.
 

millsy

4x4 Earth Contributer
There might be a rust problem with rubber. Any water getting in under the rubber will not dry out. You would never know there is water there. So I guess if you fit the rubber so its easy to lift and check, and remember to do the check regularly it would be OK.
 

Traveller

Well-Known Member
I've had water in the drivers side a few times now, still haven't worked out how/where it's getting in yet.
I ripped out all the carpet under the vinyl(I've a DX) and put underlay in it's place. If you were to use
rubber, then you could do the same, insulate the floor from noise and heat and using off cuts from a
carpet place!
Worth a thought anyway, good luck.
I might go check the drain hose from my heater box now too!!

Jok
 

mudprado

New Member
l am of the same thought we sunk our prado a month ago and was going no replace the carpet with a moulded rubber and put an underlay under it so if got wet can pull it out and wash the underlay. as now a month on still the sell of mud in it.
 

Harks76

New Member
Thanks for all the replies.

I found where the water was getting in yesterday afternoon, We had Spotlights put in a few weeks ago and I sprayed the hose around the area and sure enough a little water worked its way through.

Good points about the rubber also, I just assumed that rubber would be a much better option but as you say unless you take it out on a regular basis you would never know that it was wet underneath.

When I took the front carpet I just noticed a crap load of sand from my beach trips and though it best to do away with the carpet.

Looks like I may reconsider.

Cheers

Adam
 

millsy

4x4 Earth Contributer
Even carpet is a problem, with its thick underlay. A lot of water can hide under the carpet and underlay, or even small amounts on a regular basis, and you never know its happening. We usually don't think about it. There are more interesting things on your mind!

So eventually, many people finally lift the carpets, maybe to hide some new wiring, and find huge rust problems in the floor well. Its happened to me a few times over the years. So even with carpets you need to have a look underneath them every once in a while.

I had to take my carpets out of the Patrol a few weeks ago because I had a leak from around the door seals in the rainy weather. The carpets and underlay needed drying out. And I found rust under the driver's carpet where it had been getting wet. So when I replaced it I put some parts of the carpet back in ( it was in about 4 different sections ), but just put the underlay with the rubber floor mat sitting on top in the two front foot wells. I have not screwed the edges of the underlay down under the plastic sill cover. So now I can quickly lift it up and have a look underneath when I want to.

This summer, after all the moisture has completely dried out I will fix the damaged section with some 'rust eater' treatment and some god quality anti-rust undercoat and top coat from Wattyl paints.
 
Last edited:

Jacked Surf

Member
I had a similar issue with my surf, when i took it for a muddy swim. 2 weeks of cleaning to get the mud out. removing the carpet and peeling the carpets underlay off as it rotted slightly. Originally Carpet in the surf has a rubber backing and then had the cloth insulation / underlay beneath, drenched in muddy water. I sprayed some bedliner onto the interior floorpanels to prevent the water rusting the steel. Also sikaflexed / sealed up all rubber grommets and floor holes before spraying the bedliner. Then refitted new underlay (rubber house carpet underlay) which i purchased 8m x 2m of the stuff for $17 from bunnings.

This has pretty much sealed the interior up. Also to note water will work its way through the seat bolts so run a bead of sikaflex around those as well. I found that out the fun way when i first got my 4x4 and thought playing around in the mud at loveday was cool. Door seals and window seals are great. Floor seat bolts not so much with water bubbling up onto your feet is not fun. but you get to find the holes. that was an Time Consuming Cleanup Lesson, but Lesson Learned.

I personally prefer the carpet as it also keeps the warmth into the cabin in the cold winter months and insulates from the heat as well. Keeping the A/C working as effeciently as it can
 
Last edited:
Top